Hey, I don't know if this is a common problem or if this is just how this pedal is supposed to sound or anything, but when I engage this bad boy it is noticeably louder than my clean tone. There is also a change in the tone that I would characterize as 'warm' and 'slightly overdriven', but I assumed this was due to my choice to build the MN3007 model.
At first I assumed that the volume change was just the effect of removing R1, the pull down resistor, as suggested in the project, but even after adding this component back into the circuit I still experience a substantial increase in the noise, which is always appreciated, but is a bit unruly in this case.
Any suggestions?