Author Topic: Road Rage voltage conversion wiring  (Read 2171 times)

monkeyssj1

  • Solder Ninja
  • ****
  • Posts: 279
  • daniel
    • View Profile
Road Rage voltage conversion wiring
« on: April 19, 2012, 02:47:50 PM »
Hey guys, so I'm about to put a road rage into my jmk op amp big muff and was just wondering.... If I connect the power supply jack into the positive 9v pad and ground pad next to it like it does in the wiring diagram of the road rage, where does the -9v wire go to? (board I assume?) Also, on the JMK op amp board, the 9v pad says +9v. This is why I'm a little confused. I hope I didn't confuse any of you guys with this explanation.

gtr2

  • Electron Doctor
  • *****
  • Posts: 4788
  • Josh
    • View Profile
    • 1776 effects
Re: Road Rage voltage conversion wiring
« Reply #1 on: April 19, 2012, 03:44:45 PM »
You don't need a road rage with Jacobs project.

Just use the wiring diagram here and you'll be fine.

http://www.madbeanpedals.com/tutorials/downloads/StandardWiring_MBP.pdf

Josh
1776 EFFECTS STORE     
Contract PCB designer

monkeyssj1

  • Solder Ninja
  • ****
  • Posts: 279
  • daniel
    • View Profile
Re: Road Rage voltage conversion wiring
« Reply #2 on: April 19, 2012, 03:56:50 PM »
lmao... sweet. that's a pleasant surprise. Thanks Josh. I'm really glad I put this in the newb section