Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Martial_Sound

Pages: [1]
1
Tech Help - Projects Page / Re: Business Card Fuzz (BCF) Failure/Help
« on: April 16, 2023, 08:29:53 PM »
No they are wired correctly. Can you be more specific?

Also - I re-soldered the jack as suggested. Still no sound/same issue. This is so frustrating! Its such a small board but seemed like it was going to be fun.

2
Tech Help - Projects Page / Re: Business Card Fuzz (BCF) Failure/Help
« on: April 15, 2023, 08:49:07 PM »
Thank you very much for the advice!

3
Tech Help - Projects Page / Re: Business Card Fuzz (BCF) Failure/Help
« on: April 15, 2023, 08:22:21 PM »
Yes. My soldering job this time around was atrocious. I realize this now. Thanks for the tip I'll give it a shot first thing tomorrow and hope for the best.

4
Tech Help - Projects Page / Business Card Fuzz (BCF) Failure/Help
« on: April 15, 2023, 08:08:31 PM »
Hello,

   I'm new to pedal building. This is my second build so be gentle! My first pedal was the Woodstork21 which I completed with no issues. Now, I'm building a BCF and here's the run down:

All components installed
I did the following mods per the build PDF:
More fuzz - change fuzz pot to 2kB.
More squish - change Squish to 1MB.
More volume - change 470R resistor to 820R.
I used  2 2n3904 silicon transistors

Plugged in, I get sound when the pedal is OFF. When I engage the pedal, the LED comes on but no sound.
I checked all my connections and I can't figure it out.
What do?
Pics below:

 

5
How Do I? Beginner's Paradise. / Art Templates for 1590B?
« on: December 27, 2022, 06:19:21 PM »
Hello!
  I'm building a Woodstork and going to have Tayda UV print an enclosure for me. Problem is... there is no place on their site for templates! I see them for drilling but NOT art!

6
How Do I? Beginner's Paradise. / Re: How to get my enclosure painted?
« on: November 14, 2022, 08:14:50 PM »
Thanks! Tayda it is!

7
How Do I? Beginner's Paradise. / How to get my enclosure painted?
« on: November 14, 2022, 07:55:26 PM »
Hello! I'm building a pedal that fits into a 1590B enclosure and have a great image I want to use for it. Is there a company that will do one off printing or anything of the sort?

Thanks!
Mike/MS

8
General Questions / Re: Building a Woodstork Fuzz But...
« on: November 13, 2022, 08:36:41 PM »
Thanks so much for the heads up!

9
General Questions / Building a Woodstork Fuzz But...
« on: November 12, 2022, 08:56:59 PM »
Hello all! First post.

I'm going to build a Woodstork fuzz and plan to use it to get some really ignorant, sputtery, bias tweaking tones.  Any advice on how to get it as non musical sounding as possible? I like the external bias knob and I hope it will act in a similar fashion as the one on the DOD Carcosa Fuzz. I see that that Woodstork has an internal trim as well. Could this be the key?
Thanks in advance!
Mike/M.S.

Pages: [1]