Forum may be experiencing issues.

Main Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - in8241

Requests / DBA Space Bender?
January 28, 2023, 08:13:02 PM
DBA Space Bender, I keep youtubing this pedal. No doubt it's probably  fancy on the inside. Something similar? A chorusy/flangy delayish that can also scramble eggs?
WOW! More GAS.....

Trying to make us look bad? J/K

That is sweeeeet! I have to look into those....
Build Reports / Re: Return of the King
September 03, 2022, 10:45:14 PM
That is sweet!
Build Reports / Re: Collosalus 2022
September 03, 2022, 10:42:07 PM
Very clean, great graphics. I want one!
Build Reports / Re: ManOWar - Maxon AD900
September 03, 2022, 10:39:53 PM
Great pedal, great graphics, great playing! You nailed it!
Global Annoucements / Re: Fraudhacker flanger released
August 20, 2022, 02:26:25 PM
My day was going fine, had my mind set on the collasus mxr 117 pcb, about to pull the trigger, then I saw this.........   
Build Reports / Re: Schematic Fuzz
August 16, 2022, 12:10:04 PM
Sweet! Love the graphics. I'm thinking of building the collosalus or the current lover.
I ended up buying a dozen 9203's from jameco, works great in the circuit, theres build pics in the build section
Build Reports / Aquaboy DLX Build
August 13, 2022, 09:26:03 PM
2019 Aquaboy DLX - My new fav delay! Calibrated for a lil over 700ms, starts to degrade  after 550,  set up for self oscillation. I luv the triangle modulation. Finished with experimental hydro dipping.

Build Reports / Man o War Build
August 13, 2022, 09:20:18 PM
Man o War, calibrated at a lil over 500ms and on the verge of oscillation. It has a 7815 wired between the jack and PCB, bolted to the inside for a heatsink. I run it off an 18V supply, down to 15V, then 12V on the board. Finished with some experimental hydro dipping that continues on the back. Cleaner sounding analog delay, I really like it.

pcb says 2019, document calls for led + 9302. Looking at spec sheets VTL5C3 looks close to 9203, and it might be tight on the board, I'll order one and see if I can fit it in.

Would an xvive VTL5C3 work with the Aquaboy DLX? Having trouble sourcing 9203 LDRs.
Don't know if this has already been addressed.

Populating my Glasshole Rev 1 PCB and noticed a possible error in the document page 15 Q1 to VC fix.

The fix shows a jumper to R46, however on my pcb that is R42, which connects to pin 2 of the Rate pot. R46 is on the other side of T2 Trimm pot. Verified continuity test with DMM.