Hi guys,
after some long silence I have put up speed again and I am trying out a few new things.
I set up a project to try out PCBA (PCB and Assembly) service.
I wanted to create something usefull, so knowing that a lot of support requests sooner or later have the question: "Did you use a signal probe to veryfy your circuit?" I created this:
Link to demovideo on YouTube: https://youtu.be/C7YJBo8ySLI
Signal tracer/injector pen features:
Do you think this will be usefull for the community?
yours
Thomas
after some long silence I have put up speed again and I am trying out a few new things.
I set up a project to try out PCBA (PCB and Assembly) service.
I wanted to create something usefull, so knowing that a lot of support requests sooner or later have the question: "Did you use a signal probe to veryfy your circuit?" I created this:
Link to demovideo on YouTube: https://youtu.be/C7YJBo8ySLI
Signal tracer/injector pen features:
- handy tool - thus the pen design
- powered by 9V pedal source
- switchable signal generator burst or alternating (950Hz/1050Hz)
- switchable instrument (200mV) or line (2V) signal level
- amplifier and mini loudspaker in(on) the pen
- SMD components already soldered
Do you think this will be usefull for the community?
yours
Thomas